DIY Camera Slider Idea

After I made a test footage for my DIY Jib, I recalled my DIY Camera Slider Project that has been abandoned for along time.

The idea is to use a Tile Cutter like this:

Parts that I will use for DIY Slider are:

To improve setup time, I will not use any nuts and bolt, but instead I will use a rubber chord.

I drill a hole on the rail holders for the chord:

Here is when the chord is attached to the rail holders:

Almost done:

Now I have to make a camera plate and rail holder plates.
Hmm, Maybe I'll just steal my wife's chopping board like before and make the camera plate and rail holder plates from it.